Features and operating procedures of steel bar bending machine
2021-06-22
The Steel Bar Bending Machine belongs to the improvement of the steel bar bending structure. It is mainly composed of a mechanical part and a control part. The main components of the mechanical part are composed of a steel bar feeding mechanism, a steel bar bending mechanism and a steel bar cutting mechanism; the control system is mainly composed of a programmable controller, a contact relay, and a switching power supply. Features and operating procedures of Steel bar bending machine, its characteristic is in the structure: the two-stage brake motor and the reducer are directly connected for one-stage reduction; the small gear and the large gear mesh. Two-stage deceleration; the big gear always drives the curved disk surface to rotate; the curved disk surface is provided with a central shaft hole and a plurality of bending shaft holes; the working multiple positioning shaft holes are respectively set on the positioning square rod of the desktop. Since the two-stage brake motor and the reducer are directly connected for one-stage deceleration, the input and output speed ratio is accurate, the bending speed is stable and accurate, and the electrical automatic control can be used to change the speed. Brake can ensure the bending angle. The steel bars are bent in both directions by the forward and reverse rotation of the motor. 1. Check whether the mechanical performance is good, the workbench and the bending machine table are kept level. 2. Install the stop shaft or variable stop according to the diameter of the processed steel bar and the requirements of the bending machine 3. Check that the stopper and the turntable should be free from damage and cracks, and the operation can only be performed after the empty machine is running. 4. During operation, insert one end of the steel bar that needs to be bent into the gap provided by the turntable, and the other end is fixed against the fuselage. Check that the fuselage is fixed and it is indeed installed on the side that blocks the steel. 5. It is strictly forbidden to change the angle and adjust the speed during the operation, nor to refuel or remove. 6. When bending steel bars, it is strictly forbidden to process steel bars that exceed the diameter, number of bars and mechanical speed specified by the machine. 7. It is strictly forbidden to stand people within the working radius of the steel bar bending machine and on the side of the fuselage that is not fixed. The bent semi-finished products should be stacked neatly, and the hooks should not face upwards. Features and operating procedures of steel bar bending machine. 8. When the turntable is reversed, it must be carried out after it has stopped. 9. The work is completed, the box is shut off, the equipment is cleaned, and the site sanitation.
